Sản phẩm

DESCRIPTION

Polyurethane topcoat coating is a special UV-resistant polyurethane resin and pigment changes color with the adhesion and abrasion resistance, and there is no consumer wants color and gloss, semi-glossy, matte and beautiful appearance of a freely selectable implementation of quality products possible.

  

USES

– Apartment buildings, such as the general Exposed roof waterproofing finish top coats

– Gymnasium, tennis court, car park finish top coats

– Toilet, bathroom, etc. waterproofing top coat

– The bottom layer of elastic top coat is required (volleyball, basketball, table tennis, handball arena and a health club, playroom, classroom, etc.)

FEATURES

– Excellent weather resistance and abrasion resistance.

– You can choose from a variety of color and shine to implement a beautiful appearance.

– Excellent adhesion and water resistance

THEORETICAL AMOUNT

– 0.2~0.3 kg/m2

APPLICATION METHOD

– Surface preparation: Part of the resolution is water or oil paint, dust and paint in a clean condition by removing the.

– Old coat check: Check the status of old film peeled paint showed that there is no check and verify that the case is made completely cured.

– Environmental conditions : Air temperature 5 ~ 32℃

Relative humidity 30 ~ 85%

– Diluent usage: Make sure that the paint thinner (thinner polyurethane) is used, but the paint job, use the proper dilution ratio. If excessive use thinners will cause lack of hiding.

– Recoating time: 12hrs min, 24hrs max

– If you use the last product pot life decreases adhesion, gloss reduction, as this can cause poor appearance mixed with the required amount.

– pot life is much less than the viscosity rises, do not use the product for disposal.

– Be sure that the diluent (urethane thinners) such as epoxy paint, use your Do not use any other paint thinners.

– Reduction of excess dilution of hiding the cause. Note that

TECHNICAL INFORMATION

Colors	Green, gray, custom colors
Viscosity (cps/25℃)	250 ± 100
Specific gravity (g/㎤,25℃)	1.10 ± 0.1
Mixing ratio	1 : 3
Pot life (25℃)	30min over
Drying time(25℃)	Dry to Touch 20 minutes Dry cured within 24 hours

 * Presented technical data are changeable for quality improvement or working conditions because it have acquired from the result of laboratory test and applications.

PACKING UNIT

– Base 4kg, converter 12kg

SAFETY PRECAUTIONS

This product is a two-component reaction-curable coatings, so only the specified percentage of the product mix by stirring and then use the uniform state.